Chuck aa0hw's Blog – January 2017 Archive (5)

Remote Control of an Elecraft K3S for CW mode - using a Raspberry Pi

40 METER LIVE CW QSO with W2XB using this remote setup:

the remote site where the remote op is located, is a WINDOWS 10 computer, over the internet, connecting to the K3S Elecraft's Raspberry Pi hardware/software interface via Tight VNC viewer and JackTrip(audio). The audio from and to the K3S, is achieved in low latency using JACKTRIP(has…

Continue

Added by Chuck aa0hw on January 23, 2017 at 4:30pm — No Comments

Raspberry Pi(or LINUX) - A complete morse code cw station - using free software

- IAMBIC and STRAIGHT KEY from:https://github.com/recri/keyer

- cw keyboard is from FLdigi : http://www.w1hkj.com/

once built and compiled, the Recri Keyer software will allow both STRAIGHT KEY and IAMBIC KEYER at the same time via a USB MIDI DEVICE(s) that…

Continue

Added by Chuck aa0hw on January 16, 2017 at 11:00am — No Comments

Raspberry Pi experimental setup to control an Elecraft K3s remotely(LAN or WAN) - live demo

Using a Raspberry Pi hardware/software interface connected to an Elecraft K3S rig, this video live demo's how it works to use the RazPi remote config to connect to the K3S over a remote ip location from another computer in real time... and receive and transmit cw and ssb.(i was able to qso cw with W8ACM for this demo)

Basic Setup for…

Continue

Added by Chuck aa0hw on January 4, 2017 at 2:34pm — No Comments

Setup a MORSE CODE LAN PARTY for your cw trainees - using QmidiNET, Linux Native Reaper & a Raspberry Pi

An experimental setup simulation for a RASPBERRY Pi LAN PARTY using 6 Raspberry Pi cw ops - all connected to the Ethernet switch/router local area network...sending and receiving morse code MIDI DATA to each other, using QmidiNet with LINUX NATIVE REAPER providing all the morse code software to convert cw audio to midi messages for transmit, and…

Continue

Added by Chuck aa0hw on January 3, 2017 at 2:51pm — No Comments

Key a Raspberry Pi - sine wave code practice oscillator - with your CW KEYER - just like a RIG

The Raspberry Pi is first setup as a code practice oscillator using LINUX NATIVE REAPER and its own plugins. Then using a circuit similar to this: http://i.imgur.com/C2qYIPm.png , a 555 timer chip is keyed by a FET optoisolator that connects to a CW KEYER's key-RIG OUTPUT jack. In this video a…

Continue

Added by Chuck aa0hw on January 2, 2017 at 10:12am — 1 Comment

Monthly Archives

2024

2023

2022

2021

2020

2019

2018

2017

2016

2015

2014

2013

2012

2011

2010

2009

2008

© 2024   Created by Chuck aa0hw.   Powered by

Badges  |  Report an Issue  |  Terms of Service